Finally, an all-in-one Motorcycle LED Light Bar that functions as Running light, Brake light and Turn Signals without the need for a special RTB (run/turn/brake) module. This unique LED Light Bar comes in 6 lengths and features a Red 1/2 intensity running light and full intensity brake light across the full length of the strip. Then when either turn signal is applied that side LEDs will blink in Amber.
Use them as brake/running/turn signals, third brake lights on trunks, TourPaks, trikes and more....
5 pre-made lengths to fit just about any motorcycle fender, trunk or Tour Pak.
- Available with Clear or Smoked lens
- Features Red running & brake along with Amber turn signals
- Entire light bar illuminates as running and brake.
- As turn signal, left or right side switch from red to amber as blinker
- 120 degree viewing angle for wider visibility.
- Flexible "D" channel tube that is only .325 thick
by .325 wide
- Industrial strength double side mounting tape on
- 24 gauge teflon coated wire leads that are 2 feet
- Input voltage of 12-15 Volts DC.
Lengths & part#'s:
6.2" (p/n 4801-092),
7" (p/n 4801-102)
8" (p/n 4801-122)
9.8" (p/n 4801-152)
11" (p/n 4801-172)
14.7" (p/n 4801-232)
- Installs easily with supplied double sided 3M tape (attached to back of fixture at factory).
- Adhesion Promoter Pad (see Add to Cart below) is specifically formulated to be used with 3Mô Acrylic Foam Tape. Prepares surface for a trouble free, long lasting adhesion.
- Installation instructions included.
- 5 wire hook-up. Wires exit out the back of one end cap. Drilling of small hole required.
** NOTE** Can be flexed in an arc as if to wrap around a paint can. CAN NOT be bent in smiley or frown face direction
Will NOT work on '05 - '08 Hammer, Jackpot, Vegas, and Kingpin or other Victory models with 2-3 volt taillights.
People who buy this also purchase the Power-Tap Tour Pak Wiring Harness. A Plug-N-Play wiring harness for H-D models. No cutting or splicing wires.